WARNING

FAILURE to read manual and comply with these warnings may result in loss of load, serious property damage and/or personal injury!

DO NOT exceed working load limit as shown on package and label attached to strap. DO NOT use if any damage has been seen. STORE out of light and heat. ANCHOR point must equal recovery strap rating. DO NOT Use steering components, suspension, body, bumper or ball hitch. Vehicle frame is best attachment. WEBBING and stitching shall not be repaired. If webbing or stitching is cut or loose, remove from service. DO NOT use for lifting purposes! NO person shall be near straight path of strap. Strap may snap back if over loaded. KEEP all persons safely back from strap and vehicles. REFER to vehicle manufacturer for correct anchor points. DO NOT jerk-pull with strap. Take up slack slowly and use smooth even pull. DO NOT use hooks, chain or any other hardware with this product. DO NOT leave strap loaded, for temporary use only. It is OWNER/OPERATOR(s) responsibility to keep and maintain all warnings and instructions for future reference.

TOW DAWG TM assumes no responsibility for personal property damage resulting from any misuse of this product. If operator has ANY DOUBT if this product is within capacity or how to use properly, DO NOT USE IT.

NOT FOR HIGHWAY USE! WARRANTY VOID IF WEBBING IS CUT!

 

Tow Dawg could be yours starting at

only $119.99

 
 
TWD_homeBG_1500.jpg
 

REVOLUTIONARY

BALL HITCH

TOW STRAP

 

The Tow Dawg Story

A Need for Something Better

Tow Dawg started with a breakdown in a remote area of our ranch in 2015. Unhappy with the slipping and breaking from our traditional tow straps, we knew there was a better way. From a literal napkin sketch through six months of intensive R&D, we developed our durable, revolutionary design.

We designed Tow Dawg to be the only tow strap you’ll ever need. Whether you’re pulling up shrubs, helping a stranded motorist or removing debris, Tow Dawg is up to the task.

2-Ply Tow Dawg strap
 

Tow Dawg is a proudly American-made tow strap designed for strength. Where traditional tow straps fail, Tow Dawg can take the punishment with breaking strengths up to 61,000 lbs.

Our revolutionary design allows you to secure the fitting of this durable polyester strap over the ball of your hitch without slipping. Available in 2 Ply and 4 Ply models at lengths of 20’, 30’, 40’ there’s a Tow Dawg strap to get you out of a jam.

 
 
TWD_hitchInAction-dark_1500.jpg
 

How It Works

In 5 simple steps

 
  • 1Connect

  • 2Fit

  • 3Secure

  • 4Tighten

  • 5Pull

  • 1Connect

    Connect the opposite end of the Polyester Tow Dawg to the object being pulled.
  • 2Fit

    Place the circle of the key hole over the tow ball.
  • 3Secure

    Firmly pull to assure the shaft of the keyhole is around the shaft of the tow ball.
  • 4Tighten

    Roll forward slowly to take out ALL slack in the Tow Dawg strap.
  • 5Pull

    Once tension is formed on the Tow Dawg strap, SLOWLY pull forward.

(WARNING - Tow Dawg is not intended to be used for any recovery situations where a “snatch tactic” is applied.)

 

7Q6A0817.jpg
 

Follow Tow Dawg’s Story

@TOWDAWGUSA | #TOWDAWGNATION